User manual

ADT-HC4500 CNC Flame/Plasma Controller

c Arcing, arcing delay M12

d Perforating, perforating delay

Start the following actions

Users can define the functions of M07 as required.

4) [F2] is used to define the M08 instruction. The system default M08 instruction for closing cutting

oxygen is as follows:

Flame:

c Cutting oxygen off, M13

d Cutting gun rising (Fixed Cycle), M70

Plasma:

c Close striking arc M13

d Close the height-adjusting control M23

Users can define M08 to M80 (close all output) according to their actual demand. All valves will

be closed when performing M08 to save gas.

5) [F3]: Clear the data of current line.

6) [F4]: Add a new line below the current line.

7) [F5]: Delete the current line.

8) [F6]: Save the content.

9) [INS]: Open the help system of the current interface

Note: After you have defined M07 and M08 instructions, you should set [F1] (Configuration) in [F4]

(Parameter) as “user-defined”; otherwise, the instructions would not be effective.

3.2 Editing processing file

As shown in Picture 3.1 at the beginning of this section, in the interface of editing, if you create a new file

or load a file, and enter the edition interface, you can then edit the processing file as follows: