User manual

ADT-HC4500 CNC Flame/Plasma Controller
55
default or user-defined mode. For definition, see “Definition” in section 3.
Language: Choose the language. The system supports operating interface of many languages.
Machine: Two cutting processes are provided, flame cutting or plasma cutting.
Theunit(Metric/Imperial): It is only available before entering into the auto mode or testing the program.
Operation mode: You can press [Y+] or [Y-] to move the cursor up or down, [X+] or [X-] to change the
mode, or [F6] to save the parameters.
4.1.1 Height-adjusting (Pset)
In configuration parameter setting interface as above, you can press [F2] to enter the interface of
height-adjusting parameter settings:
Picture 4.1.1 Height adjusting
Perallow: An extra arc voltage adjustor is added to control when the arc voltage adjusting starts to work
and when it stops.
INITLOCA(Initial positioning): The cutting gun runs a fixed rising height when encountering the steel
plate.
Arc test: A signal is fed back by plasma power supply, with which the system will run the track in case of
successful arcing; otherwise, it will stop running the track.
Operation mode: You can press [Y+] or [Y-] to move the cursor up or down, [X+] or [X-] to change the
mode, or [F6] to save the parameters.