User manual

ADT-HC4500 CNC Flame/Plasma Controller
58
4.3 Adjustment (Adju)
In system parameter setting interface as Picture 4, press [F3] and the interface will become as the
following picture, when you can set the limit coordinate, origin coordinate, and backlash.
Picture 4.3Adjusting parameter settings
4.3.1 Adjustment settings
Parameter Explanation Unit
Limit + Positive limit of system; when the current position is larger
than this value, the system will stop automatically
mm
Limit - Negative limit of system; when the current position is smaller
than this value, the system will stop automatically
mm
Mac(hine)origin Origin position of machine mm
Reccleara(X) Gap compensation when X axis is reversing mm
Reccleara (Y) Gap compensation when Y axis is reversing mm
Table 4.3.1
4.4 Control (Ctrl)
In system parameter setting interface as Picture 4, press [F4] and the interface will become as the
following picture, when you can set the X/Y motor moving speed, preheating and cutting gun rising/falling
time during the auto processing.