User manual

ADT-HC4500 CNC Flame/Plasma Controller
59
Picture 4.4.1 ① Flame
Picture 4.4.2 ② Plasma
Parameter Explanation Unit
CutHoleOutside Whether to enable the edge perforating prompt when
perforating
Preheat delay Preheating time of perforating on the steel plate,
which can be adjusted
0.01 sec
CutGun rising delay It is usually used before G00 shifting position to lift
the cutting gun to a proper height with a purpose of
avoiding the collision of cutting gun and steel plat
when re-transferring.
0.01 sec
Cutgun falling delay It’s the opposite action of cutting gun rising delay.
Lower the cutting gun to a proper height, and after
G00 transfer, it is required to lower the cutting gun
0.01 sec