User manual

ADT-HC4500 CNC Flame/Plasma Controller

4.6 Save

You should press [F6] once every time when the value of a submenu in “Parameter” is modified; otherwise,

the modified value would not be saved.

5. Diagnosis (Diag)

Press [F5] in main interface, and the system will enter the diagnosis interface as Picture 2.6 below:

Picture 5 Diagnosis interface

5.1 Sub-menu

1) Diagnosis interface

In diagnosis interface as Picture 5, press [F1] to enter the diagnosis testing interface as Picture

5.1.1:

Operating instructions:

[F1]: Test the positive rotation of X axis

[F2]: Test the contrarotation of X axis

[F3]: Test the positive rotation of Y axis

[F4]: Test the contrarotation of Y axis

[F5]: Stop the current X/Y rotation

You can press [X+], [X-], [Y+], or [Y-] to move the output cursor, and then press OK to output

the relevant switching signal.

If there is an input signal, a ‘*’ will show below the relevant pin sign of input diagnosis.