User`s manual

http://www.adtechcn.com 103
Figure 11
In the properties window for TCP/IP protocol, select “use the IP address below”. Then the user
can set the host’s IP address, subnet mask and default gateway in accordance with the subnet
number of the LAN where the host is installed. If no real gateway exists in the subnet, the
gateway can be set as the number of the first host in the subnet, like “192 . 168 . 0 . 1”.
In actual use, the subnet number should be consistent with that of the host. If not, the user can
modify the network configuration files of the control card through the serial interface software
tool to make them so. Of course, if the control card is connected to the host via the crossover
cable, the user can also modify the IP address of the host to accommodate host to the control card.