User`s manual

http://www.adtechcn.com 97
Figure 2
After the user enters the command “:000004”in the test/configuration interface and click Send or
Enter, the system will enter the state of network configuration for the control card. The actual
command related to the network configuration appears on the screen again, as shown in Figure 3:
Figure 3
Figure 3 shows there are six commands for network configuration, the top four of which provide
the format of the command and indicate the command characters are associated with the content
of configuration. If the format of input command has error, the error will be prompted in the
screen. If the input command is correct, what is entered will be displayed again, as shown in
Figure 4.
Before network configuration is saved, the user must ensure IP address, adder mask, gateway IP
and network adapter address have been correctly set. Otherwise, the system will prompt the
related item has not been configured, as shown in Figure 5.