User manual

Chapter 9. Transaction Language 1 (TL1)
61185001L1-1 MX2810 M13 User Manual 9-11
For possible CONDTYPE codes for both REPT-ALM and
REPT-EVT quoted lines, refer to the condition types listed in Table
9-4 on page 9-19 and Table 9-5 on page 9-22, respectively.
See the section TL1 Autonomous Messages on page 9-17 for a list of
autonomous messages currently supported by the MX2810.
TL1 COMMANDS
As stated in TL1 Messages on page 9-4, the general format for a TL1
command is:
Areas of concentration for TL1 support in the MX2810 include
session initiation, session termination, and system event reporting.
Table 9-3 lists the commands currently supported by the MX2810.
<VERB>[-<MOD1>[-<MOD2>]]:[<TID>]:[<AID>]:[<CTAG>]:[GB](:<PARAMx>(,<PARAMx>)*)*;
The Target ID (TID) is the same as the unit’s Unit ID (See VT100
menus: Configuration/System Management/Equipment Identification.)
Table 9-3. TL1 Commands
ACT-USER::<username>:::<password>;
Description Initiates a TL1 session
TID* Target ID
AID Username (must be present in the User Account
Management table)
CTAG* Transaction Number (integer)
PARAM1 Password for associated username
ALW-MSG-{EQPT|rr|ALL};
Description Allows the transmission of the requested autonomous
alarm(s)
* An asterisk indicates optional command blocks.