Specifications

Section 4 User Interface Guide Total Access 600R System Manual
50 © 2002 ADTRAN, Inc. 61200600L1-1A
SYSTEM CONFIG > MANAGEMENT > SNMP MANAGEMENT
Activate the SNMP management and configure the SNMP communities and traps from this menu.
SYSTEM CONFIG > MANAGEMENT > SNMP MANAGEMENT > ACCESS
When set to OFF, SNMP access is denied. When set to ON, the unit will respond to SNMP managers based
on the configuration. The factory default is
ON.
SYSTEM CONFIG > MANAGEMENT > SNMP MANAGEMENT > COMMUNITIES
Set up the SNMP communities parameters from this menu.
#
Displays the index number of the SNMP Communities.
This list is used to set up to eight SNMP communities that the unit will allow.
NAME
This is the text string used to identify the SNMP community. The factory default is no entry in the
name parameter.
PRIVILEGE
The access for this manager can be assigned three levels. The factory default is GET.
NONE
No access is allowed for this community or manager.
GET
Manager can only read items.
GET/SET
Manager can read and set items.
MANAGER IP
This may be used in conjunction with the Netmask field to define a range of manager IPs. A netmask
of 255.255.255.255 defines a single IP as the manager host IP. The default value is
0.0.0.0.
NETMASK
The mask is used to determine which bits of the MANAGER IP are significant. A "0" bit means "don't
care." A "1" bit means that the corresponding address bits in the incoming SNMP packet must match
the address bit in the defined
MANAGER IP. The netmask of 255.255.255.255 defines a single IP as
the manager host IP. The default value is
0.0.0.0.