User's Manual
Table Of Contents
- 6304W Configuration Guide_1.01
- 6304W ONU Gateway Configuration Guide
- CHAPTER 1 Getting Started
- CHAPTER 2 Logging into the Web GUI
- CHAPTER 3 Viewing Device Information
- CHAPTER 4 Viewing WAN Interface Information
- CHAPTER 5 Configuring WAN Interfaces
- CHAPTER 6 Configuring Wi-Fi
- CHAPTER 7 Viewing Wi-Fi Information
- CHAPTER 8 Configuring Voice Service
- CHAPTER 9 Configuring NTP
- CHAPTER 10 Configuring Static Routing
- CHAPTER 11 Restarting the Device
- CHAPTER 12 Reverting to the Default Setting
- CHAPTER 13 Upgrading Software
- CHAPTER 14 Configuring Backups
- CHAPTER 15 Restoring Configuration Files
- CHAPTER 16 Performing Diagnostics
- 组合 1
- 组合 3
- 6304W Installation Guide_1.01_部分1_部分1
- 组合 1
- 6304W Installation Guide_1.01_部分2
- 6304W Installation Guide_1.01_部分3
- 6304W Installation Guide_1.01_部分4
- 6304W Installation Guide_1.01_部分5
- 6304W Installation Guide_1.01_部分6
- 6304W Installation Guide_1.01_部分7
- 6304W Installation Guide_1.01_部分8
- 6304W Installation Guide_1.01_部分9
- 6304W Installation Guide_1.01_部分10
- 6304W Installation Guide_1.01_部分11
- 警语
- 组合 3
6304W Installation Guide 7
CHAPTER 4 Installing the ONU
This chapter provides instructions on how to install the ONU.
Connecting the Fiber
Before connecting the product to the fiber, you need to install the fiber. Follow these
steps to install the fiber.
1 Remove the dust cap from the optical interface.
2 Insert the fiber into the flange plate.
3 Connect the fiber from the flange plate to the optical interface on the wall.
Note
• When a fiber is not in use, cover the optical interface of the ONU and put the dust
cap back on the optical fiber. Prevent dust pollution or water immersion, as this
may cause damage to the fiber and optical interface of the ONU.
• If fibers need to be fixed during parallel cabling, do not fasten the fibers too tightly.
Avoid fiber extrusion, as this may cause fiber damage.