User's Manual
Table Of Contents
- 6304W Configuration Guide_1.01
- 6304W ONU Gateway Configuration Guide
- CHAPTER 1 Getting Started
- CHAPTER 2 Logging into the Web GUI
- CHAPTER 3 Viewing Device Information
- CHAPTER 4 Viewing WAN Interface Information
- CHAPTER 5 Configuring WAN Interfaces
- CHAPTER 6 Configuring Wi-Fi
- CHAPTER 7 Viewing Wi-Fi Information
- CHAPTER 8 Configuring Voice Service
- CHAPTER 9 Configuring NTP
- CHAPTER 10 Configuring Static Routing
- CHAPTER 11 Restarting the Device
- CHAPTER 12 Reverting to the Default Setting
- CHAPTER 13 Upgrading Software
- CHAPTER 14 Configuring Backups
- CHAPTER 15 Restoring Configuration Files
- CHAPTER 16 Performing Diagnostics
- 组合 1
- 组合 3
- 6304W Installation Guide_1.01_部分1_部分1
- 组合 1
- 6304W Installation Guide_1.01_部分2
- 6304W Installation Guide_1.01_部分3
- 6304W Installation Guide_1.01_部分4
- 6304W Installation Guide_1.01_部分5
- 6304W Installation Guide_1.01_部分6
- 6304W Installation Guide_1.01_部分7
- 6304W Installation Guide_1.01_部分8
- 6304W Installation Guide_1.01_部分9
- 6304W Installation Guide_1.01_部分10
- 6304W Installation Guide_1.01_部分11
- 警语
- 组合 3
Installing the ONU
8 6304W Installation Guide
Connecting the Power Adapter and Power Cord
Follow these steps to connect the power adapter to the ONU.
1 Insert one end of the power cord attached with the power adapter into the
POWER connector.
2 Press the ON/OFF button to ensure that the power status is ON.
3 Check whether the Power LED is on. If it is on, the power supply is normal.
Otherwise, check whether the power cord and the power adapter are correctly
connected.
Follow these steps to connect the UPS to the ONU.
1 Insert one end of the power cord attached with the UPS device into the UPS slot.
2 Press the ON/OFF button to ensure that the power status is ON.
3 Check whether the Power LED is on. If it is on, the power supply is normal. Oth-
erwise, check whether the power cord and the UPS device are correctly con-
nected.
Connecting the Ethernet Port
Follow these steps to connect to the Ethernet port.
1 Insert one end of a network cable with an RJ-45 connector into the Ethernet
port.
2 Insert the other end of the cable to a PC or Switch.
3 Check whether the Link LED is on. If it is on, the link is connected and
operational. Otherwise, check whether the cable is plugged in properly.
Connecting the POTS Port
Follow these steps to connect to the POTS port.
1 Insert one end of a cable with an RJ-11 connector into the POTS port.
2 Insert the other end of the cable to a telephone.