User's Manual
Table Of Contents
- 6304W Configuration Guide_1.01
- 6304W ONU Gateway Configuration Guide
- CHAPTER 1 Getting Started
- CHAPTER 2 Logging into the Web GUI
- CHAPTER 3 Viewing Device Information
- CHAPTER 4 Viewing WAN Interface Information
- CHAPTER 5 Configuring WAN Interfaces
- CHAPTER 6 Configuring Wi-Fi
- CHAPTER 7 Viewing Wi-Fi Information
- CHAPTER 8 Configuring Voice Service
- CHAPTER 9 Configuring NTP
- CHAPTER 10 Configuring Static Routing
- CHAPTER 11 Restarting the Device
- CHAPTER 12 Reverting to the Default Setting
- CHAPTER 13 Upgrading Software
- CHAPTER 14 Configuring Backups
- CHAPTER 15 Restoring Configuration Files
- CHAPTER 16 Performing Diagnostics
- 组合 1
- 组合 3
- 6304W Installation Guide_1.01_部分1_部分1
- 组合 1
- 6304W Installation Guide_1.01_部分2
- 6304W Installation Guide_1.01_部分3
- 6304W Installation Guide_1.01_部分4
- 6304W Installation Guide_1.01_部分5
- 6304W Installation Guide_1.01_部分6
- 6304W Installation Guide_1.01_部分7
- 6304W Installation Guide_1.01_部分8
- 6304W Installation Guide_1.01_部分9
- 6304W Installation Guide_1.01_部分10
- 6304W Installation Guide_1.01_部分11
- 警语
- 组合 3
FCC Regulations
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
N
OTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/ TV technician for help.
Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the
equipment.
FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device
and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.
“To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The
antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and
must not be co-located or operating in conjunction with any other antenna or transmitter.”