Instruction manual

Total Access 850 System Manual Section 4 User Interface Guide

INTERFACES (ETH)

View the Ethernet interface status and configure the Ethernet parameters from this menu.

INTERFACES (ETH) > CONFIG

Configure the various Ethernet parameters from this menu.

INTERFACES (ETH) > CONFIG > AUTO NEGOTIATION

The Total Access 850 has the capability of auto negotiating the rate and duplex of the connected Ethernet

link. Additionally, when this parameter is set to

OFF, the rate and duplex are set manually. Auto

Negotiation is only available when using a 3rd Generation RCU with the Total Access 850 system.

INTERFACES (ETH) > CONFIG > DATE RATE

Defines the Ethernet interface as 100BASET or 10BASET. Data Rate configuration is only available when

using a 3rd Generation RCU with the Total Access 850 system.

INTERFACES (ETH) > CONFIG > DUPLEX TYPE

Defines operation on the Ethernet interface as FULL DUPLEX or HALF DUPLEX. Duplex Type configuration is

only available when using a 3rd Generation RCU with the Total Access 850 system.

INTERFACES (ETH) > STATUS

Displays the Ethernet status information.

INTERFACES (ETH) > STATUS > MAC ADDRESS

(Read only) Displays the unique MAC address programmed at ADTRAN.

INTERFACES (ETH) > STATUS > DATA LINK

Displays the current status of the Ethernet link as either UP or DOWN. If there is an active Ethernet link, the

status displays

UP. Data Link status information is only available when using a 3rd Generation RCU with

the Total Access 850 system.

INTERFACES (ETH) > STATUS > DATA RATE

Displays the Ethernet interface current rate of operation (as defined by the DATA RATE configuration

parameter).

INTERFACES (ETH) > STATUS > DUPLEX TYPE

Displays the Ethernet interface current mode of operation (as defined by the DUPLEX TYPE configuration

parameter). Duplex Type status information is only available when using a 3rd Generation RCU with the

Total Access 850 system.