Instruction manual

Total Access 850 System Manual Section 4 User Interface Guide
64203376L1-1B © 2004 ADTRAN, Inc. 123
L2 PROTOCOL (T1 TDM–T1–FRE) > STATUS > PORT
View the Frame Relay statistics on the WAN port.
L2 PROTOCOL (T1 TDM–T1–FRE) > STATUS > PORT > PORT INDEX
Integer used for identifying DLCIs on an interface. A single DLCI will always be port index 0. Subsequent
DLCIs will have incrementing port indices.
L2 PROTOCOL (T1 TDM–T1–FRE) > STATUS > PORT > SIGNAL STATE
Displays “up” when the unit is communicating with the Frame Relay switch; otherwise displays “down”.
L2 PROTOCOL (T1 TDM–T1–FRE) > STATUS > PORT > TX FRAMES
Total frames transmitted out the WAN port.
L2 PROTOCOL (T1 TDM–T1–FRE) > STATUS > PORT > RX FRAMES
Total frames received from the WAN port.
L2 PROTOCOL (T1 TDM–T1–FRE) > STATUS > PORT > TX BYTES
Total bytes transmitted out the WAN port.
L2 PROTOCOL (T1 TDM–T1–FRE) > STATUS > PORT > RX BYTES
Total bytes received on the WAN port.
L2 PROTOCOL (T1 TDM–T1–FRE) > STATUS > PORT > CURRENT UTIL (b/s)
Current utilization of the T1 interface bandwidth presented in bits per second.
L2 PROTOCOL (T1 TDM–T1–FRE) > STATUS > PORT > CURRENT UTIL (%)
Current utilization of the T1 interface bandwidth presented in percentage format.
L2 PROTOCOL (T1 TDM–T1–FRE) > STATUS > PORT > AVERAGE UTIL (b/s)
Average utilization of the T1 interface bandwidth (since the last stats reset) presented in bits per second.
L2 PROTOCOL (T1 TDM–T1–FRE) > STATUS > PORT > AVERAGE UTIL (%)
Average utilization of the T1 interface bandwidth (since the last stats reset) presented in percentage format.
L2 PROTOCOL (T1 TDM–T1–FRE) > STATUS > PORT > FULL STATUS TX FRAMES
Number of full status frames transmitted out the WAN port.
L2 PROTOCOL (T1 TDM–T1–FRE) > STATUS > PORT > FULL STATUS RX FRAMES
Number of full status frames received on the WAN port