Instruction manual

Total Access 850 System Manual Section 4 User Interface Guide

L2 PROTOCOL (T1 TDM–T1–FRE) > STATUS > PVC(S) > RX BYTES

Number of Frame Relay bytes that have been received via this DLCI.

L2 PROTOCOL (T1 TDM–T1–FRE) > STATUS > PVC(S) > DE COUNT

Number of packets received on this DLCI with the Discharge Eligible (DE) bit set.

L2 PROTOCOL (T1 TDM–T1–FRE) > STATUS > PVC(S) > CR COUNT

Number of packets received on this DLCI with the Command Response (CR) bit set.

L2 PROTOCOL (T1 TDM–T1–FRE) > STATUS > PVC(S) > BECN COUNT

Number of packets received on this DLCI with the Backward Explicit Congestion Notification (BECN) bit

set.

L2 PROTOCOL (T1 TDM–T1–FRE) > STATUS > PVC(S) > FECN COUNT

Number of packets received on this DLCI with the Forward Explicit Congestion Notification (FECN) bit

set.

L2 PROTOCOL (T1 TDM–T1–FRE) > STATUS > PVC(S) > UNKNOWN FRAME RX

Number of frames that have been received that the unit does not know where to route.

L2 PROTOCOL (T1 TDM–T1–FRE) > STATUS > PVC(S) > CLEAR STATS

Clears all gathered statistics for this interface and returns counters to 0.

L2 PROTOCOL (T1 TDM FIRMWARE) – T1 INTERFACE > HDLC PROTOCOL

View the status of the T1 interface with the L2 PROTOCOL set to HDLC.

L2 PROTOCOL (T1 TDM–T1–HDLC) > STATUS

View the status of traffic flow and utilization for the T1 interface with an L2 PROTOCOL set to HDLC.

L2 PROTOCOL (T1 TDM–T1–HDLC) > STATUS > TX PKTS

Number of packets transmitted on the T1 interface.