Instruction manual

Total Access 850 System Manual Section 4 User Interface Guide
64203376L1-1B © 2004 ADTRAN, Inc. 127
L2 PROTOCOL (T1 TDM–T1–AUTO) > STATUS > STATE
This field represents the state of the auto detect/configuration function. The possible state are:
L2 PROTOCOL (T1 TDM–T1–AUTO) > STATUS > TX PKTS
Number of packets transmitted out of the WAN port.
L2 PROTOCOL (T1 TDM–T1–AUTO) > STATUS > RX PKTS
Number of packets received on WAN port.
L2 PROTOCOL (T1 TDM–T1–AUTO) > STATUS > TX BYTES
Number of bytes transmitted out of the WAN port.
L2 PROTOCOL (T1 TDM–T1–AUTO) > STATUS > RX BYTES
Number of bytes received out of the WAN port.
L2 PROTOCOL (T1 TDM–T1–AUTO) > STATUS > CLEAR STATS
Clears all the gathered statistics for this interface and returns the counters to 0.
OFF
The T1 interface is down, so the auto-detect/configuration process is
currently idle.
DETECTING L2
P
ROTOCOL
The T1 interface is up and waiting for the first control/signaling packet.
CONFIRMING FR
The T1 interface is up and one FR signaling packet has been received
CONFIRMED FR
The T1 interface is up and two FR signaling packets have been received.
It takes two consecutive control/signaling packets of the same type to
confirm the detected protocol.
CONFIRMING PPP
The T1 interface is up and one PPP control packet has been received.
CONFIRMED PPP
The T1 interface is up and two PPP control packets have been received. It
takes two consecutive control/signaling packets of the same type to
confirm the detected protocol.