Instruction manual

Total Access 850 System Manual Section 4 User Interface Guide
64203376L1-1B © 2004 ADTRAN, Inc. 133
L2 PROTOCOL (T1 ATM–T1–ATM) > CONFIG > PVC CONFIG > SETUP (V35)
Use these menus to configure the V35 parameters for this logical connection from the T1 interface to the
V.35 port. These menus are only applicable when the
CONNECTION parameter is set to V35.
MAX CONFIG
This value is the number of unanswered configuration-requests that should be
transmitted before resetting PPP negotiations. the possible values are
5, 10, 15,
and
20 (def).
MAX TIMER (SEC)
This value is the number of seconds to wait between unanswered
configuration-requests. The possible values are
1 SEC, 2 SECS, 3 SECS (DEF),
5 SECS, and 10 SECS.
MAX FAILURE
Due to the nature of PPP, configuration option may not be agreed upon between
two PPP peers. This value is the number of configuration-naks that should occur
before an option is configuration-rejected. The possible values are
5 (DEF), 10,
15, and 20.
FORCE PEER IP ADDRESS
This option forces the PPP to negotiate the IP address entered instead of
allowing another address to be assigned by the remote end. The default is
NO.
KEEPALIVE PERIOD
This option allows the user to generate PPP keepalive packets that can be sent
every
1 minute, 2 minutes, or every 5 minutes. A value of 0 (OFF) disables the
PPP keepalive packet generating feature. The default is
0 (OFF).
PPP ENCAPSULATION
This option allows the user to set the encapsulation modes for PPP over ATM.
LLC has an encapsulation header in the AAL5 frame indicating it is
encapsulating PPP. VC-Mux does not have a header, and is therefor dedicated to
using PPP. The choices are
LLC or VC-MUX. The default is VC-MUX.
CONNECTION (V35) > SETUP > SETUP
Use these menus to configure the Protocol mapping, DE map, and FECN map for the V.35 PVC
connections.