Instruction manual

Total Access 850 System Manual Section 4 User Interface Guide

L2 PROTOCOL (T1 ATM–T1–CUMTN) > STATUS

View the status of the Copper Mountain DLCI connections.

L2 PROTOCOL (T1 ATM–T1–CUMTN) > STATUS > NUM

Displays the index number for the Status menu entries.

L2 PROTOCOL (T1 ATM–T1–CUMTN) > STATUS > SUB-INTERFACE

The T1 SUB-INTERFACE is CuMtn[0.0] when the L2 PROTOCOL is set for CUMTN FRE. The [0.0] represents

the T1 physical and logical ports respectively. This is a read-only field.

L2 PROTOCOL (T1 ATM–T1–CUMTN) > STATUS> DLCI STATE

This is a read-only field that displays the live DLCI state.

L2 PROTOCOL (T1 ATM–T1–CUMTN) > STATUS > PROTOCOL STATUS

This is a read-only field that displays the live protocol status. Menu visible for physical and logical VOICE

ports only.

L2 PROTOCOL (T1 ATM–T1–CUMTN) > STATUS > PROTOCOL STATUS > POTS STATS

View the voice port activity and coding type.

L2 PROTOCOL (T1 ATM–T1–CUMTN) > STATUS > PROTOCOL STATUS > CLEAR STATS

Clears all recorded statistics for the interface and returns all counters to 0.

L2 PROTOCOL (T1 ATM FIRMWARE) – V.35 INTERFACE

Configure the L2 PROTOCOL parameters and view the status of the V.35 interface using items from this

menu. The V.35 interface is only available when the configured T1 network protocol is ATM. Refer to L2

Protocol (T1 ATM Firmware) – T1 Interface > ATM on page 129.

L2 PROTOCOL (T1 ATM – V35) > PROTOCOL

Configure the L2 PROTOCOL mode. Choices are FRF5 (def) and FRF8. Selecting FRF5 configures the

interface for network interworking and should be used for Frame Relay over ATM applications. Selecting

FRF8 configures the interface for service interworking allowing the Total Access 850 to make the

translation between Frame Relay signaling on the V35 interface and ATM protocols on the network

interface.

L2 PROTOCOL (T1 ATM – V35) > CONFIG

Configures the L2 PROTOCOL parameters for either FRF5 or FRF8 signaling.