Instruction manual

Section 4 User Interface Guide Total Access 850 System Manual

L2 PROTOCOL (ALL FIRMWARE) – ETH INTERFACE > 802.3 PROTOCOL

Configure the L2 PROTOCOL parameters and view the status of the Ethernet interface from this menu.

L2 PROTOCOL (ALL–ETH–802.3) > PROTOCOL

Displays the L2 PROTOCOL for the 10/100BaseT Ethernet port. Currently only 802.3 is supported.

L2 PROTOCOL (ALL–ETH–802.3) > CONFIG

Configure the mode for this 10/100BASET Ethernet port from this menu.

L2 PROTOCOL (ALL–ETH–802.3) > CONFIG > MODE

The mode identifies how the data will be forwarded. The choices are:

L2 PROTOCOL (ALL–ETH–802.3) > STATUS

View the L2 PROTOCOL statistics for the 10/100BASET Ethernet port from this menu.

L2 PROTOCOL (ALL–ETH–802.3) > STATUS > TX PACKETS

Total number of packets transmitted out the Ethernet port.

L2 PROTOCOL (ALL–ETH–802.3) > STATUS > RX PACKETS

Total number of packets received from the Ethernet port.

L2 PROTOCOL (ALL–ETH–802.3) > STATUS > TX ERRORS

Total number of transmit errors encountered on Ethernet port.

L2 PROTOCOL (ALL–ETH–802.3) > STATUS > SINGLE COLLISIONS

Total number of single collisions before successful transmission.

L2 PROTOCOL (ALL–ETH–802.3) > STATUS > MULTIPLE COLLISIONS

Total number of multiple collisions before successful transmission.

L2 PROTOCOL (ALL–ETH–802.3) > STATUS > EXCESSIVE COLLISIONS

Total number of collisions that resulted in packet being dropped.

L2 PROTOCOL (ALL–ETH–802.3) > STATUS > DEFERRED TRANSMISSIONS

Total number of packets deferred due to collisions.

L2 PROTOCOL (ALL–ETH–802.3) > STATUS > CARRIER SENSE ERRORS

Total number of carrier sense errors encountered (no link integrity).

ROUTE IP (def) All IP data will be routed

RIDGE ALL All data will be bridged

OUTE IP/BRIDGE OTHER All IP data will be routed. All other data will be bridged.