Instruction manual

Total Access 850 System Manual Section 4 User Interface Guide

PRIVATE PORT MODE

Select ANY PORT (default) or a SPECIFIED port number for this translation. The

private destination port associated with this entry can be specified to provide

more control over certain types of traffic. Leave configured as

ANY PORT to

cover all port types.

PRIVATE PORT MODE

This menu appears when the PRIVATE PORT MODE is set to SPECIFIED, and allows

the user to enter the port number that replaces the public port number during the

translation of incoming packets. Outgoing packets from the private address

space that match this protocol are sent to the specified public address and port, if

any.

TRANSLATE BODY

If set to YES, the application payload in the packet is scanned for occurrences of

the private/public IP address in binary or ASCII form. Set this to

NO for

applications where scanning payload data is undesirable.

NAT VIEW

Provides the user a dynamic view of current active router translations. Once the router has

translated an inbound or outbound packet, the translation appears in this table. The main view is

a listing of all the translations performed thus far. In order to see the detailed view of one of the

entries, select the entry index number and press

<ENTER>. The NAT View parameters are as

follows:

PRIVATE ADDRESS

Private IP address of the active translation.

PUBLIC ADDRESS

Public IP address of the active translation.

SERVER ADDRESS

Server IP address of the public device.

PROTOCOL

Type of protocol active on the translation.

PRIVATE PORT

Private port number used for the translation.