Instruction manual

Total Access 850 System Manual Section 4 User Interface Guide

ROUTER > CONFIG > UDP RELAY

This menu configures the unit to act as a UDP relay agent for applications requiring a response from UDP

hosts that are not on the same network segment as their clients.

ROUTER > CONFIG > UDP RELAY > MODE

When this option is set to ON, the unit will act as a relay agent. Default is OFF.

ROUTER > CONFIG > UDP RELAY > UDP RELAY LIST

Up to four relay destination servers can be specified in this list.

ROUTER > STATUS

View the IP ROUTES, IP STATS, ARP CACHE, DHCP SERVER, and DHCP CLIENT statistics from this menu.

ROUTER > STATUS > IP ROUTES

This lists the contents of the unit’s IP route table.

ROUTER > STATUS > IP ROUTES > IP ADDRESS

Network or host destination address.

ROUTER > STATUS > IP ROUTES > NETMASK

Network mask applied to the destination address.

ROUTER > STATUS > IP ROUTES > GATEWAY

Host or router to receive this packet.

Indicates the entry number in the UDP Relay List table.

RELAY ADDRESS

This is the IP address of the server that will receive the relay packet. Default is 0.0.0.0.

UDP PORT TYPE

The choices are STANDARD (def) and SPECIFIED. The following standard UDP protocols are relayed

when set: DHCP, TFTP, DNS, NTP (Network Time Protocol, port 123), NBNS (NetBios Name

Server, port 137), NBDG (NetBIOS Datagram, port 138), and BootP. When

SPECIFIED is set, the

UDP port (1 to 65535) can be specified in the UDP Port columns (up to three per server).

UDP PORT 1, 2, 3

Used for specifying UDP ports to be relayed. These fields only apply when UDP PORT TYPE is set to

SPECIFIED. Default is 0.