Instruction manual

Section 4 User Interface Guide Total Access 850 System Manual

NUM

Indicates the entry number in the IP Filter Defines table.

NAME

Identifies the filter entry. Default is no entry in name field.

FILTER TYPE

Specifies a NORMAL or DEBUG filter. When a NORMAL filer is applied to an interface, traffic is blocked

or forwarded according to the filter. When a

DEBUG filter is applied, packets that match the filter are

documented without affecting traffic flow. (Use the

DEBUG filter with the Syslog or Terminal Mode

logging to view the packet contents.)

SRC ADDR

IP address compared to the source address. Value is in dotted decimal format. Default is 0.0.0.0.

SRC MASK

Bits which are used in the source comparison. Value is in dotted decimal format. Default is 0.0.0.0.

DEST ADDR

IP address compared to the destination address. Value is in dotted decimal format. Default is 0.0.0.0.

DEST MASK

Bits which are used in the destination comparison. Value is in dotted decimal format. Default is

0.0.0.0.

SRC PORT

IP source port number used for comparison. Value is in decimal format. Range: 0 - 65535. Default is

SRC PORT COMP

Type of comparison that is performed. Default is NONE.

= means ports equal to

NOT = means port not equal to

> means port greater than

< means port less than

None - means the source port is not compared