Instruction manual

Total Access 850 System Manual Section 4 User Interface Guide
64203376L1-1B © 2004 ADTRAN, Inc. 183
2. Configuring the Layer 2 Protocol
For more details on the configuration parameters discussed in this section, refer to the following pages:
Layer 2 Frame Relay Protocol menus beginning on page 121
Layer 2 PPP Protocol menus beginning on page 118
Layer 2 Ethernet menus beginning on page 144
Ethernet Interface Setup Instructions
Most applications should not require a manual setup for the Ethernet interface. By
default, the Ethernet interface is configured to auto-detect the data rate (as either 10
or 100 Mbps). The following steps disable the auto-negotiation parameter and
manually configure the interface.
Step Action
1
From the main menu, select INTERFACES.
2
Highlight the CONFIG menu for the ETH interface and press <ENTER>.
3
Use the right arrow to select AUTONEGOTIATION and press <ENTER>. Use the
down arrow to choose OFF.
4 Select the DATA RATE field and specify either 10BASET or 100BASET.
5 Select the DUPLEX TYPE field and specify either HALF DUPLEX or FULL DUPLEX.
Layer 2 Protocol (FRE) Configuration – T1 Interface
Step Action
1
From the main menu, select L2 PROTOCOL and press <ENTER>.
2
Use the arrow keys to select the PROTOCOL field for the T1 interface. Press
<E
NTER>. Select FRE from the list of available protocols.
3 Highlight the CONFIG menu for the T1 interface and press <ENTER>.
4
Set the MAINTENANCE PROTOCOL to ANNEX D (ANSI), ANNEX A (q933a), LMI, OR
S
TATIC (no sig).
The MAINTENANCE PROTOCOL should be set based on the Frame Relay switch.
5
Down arrow and press <ENTER> on DLCI MAPPING. Press the right arrow key to
create an entry. To create additional entries, highlight the N
UM field and press
the <I> key. To delete an entry, highlight the N
UM field for the entry to delete
and press the <D> key.
6 Set ACTIVE to YES.