Instruction manual

Section 4 User Interface Guide Total Access 850 System Manual
190 © 2004 ADTRAN, Inc. 64203376L1-1B
7
Set DLCI to the DLCI number. This DLCI should match what is programmed in
the network Frame Relay switch.
8
Set mode to BRIDGE ALL. Using this menu you also have the option to route
only IP packets and bridge all other data packets (R
OUTE IP/BRIDGE OTHER) or
route all IP data packets on this PVC (R
OUTE IP).
9 Left arrow back to the main menu to save the changes.
Layer 2 Protocol (PPP) Configuration – T1 Interface
Step Action
1
From the main menu, select L2 PROTOCOL and press <ENTER>.
2
Use the arrow keys to select the PROTOCOL field for the T1 interface. Press
<E
NTER>. Select PPP from the list of available protocols.
3 Highlight the CONFIG menu for the T1 interface and press <ENTER>.
4
Set mode to BRIDGE ALL. Using this menu you also have the option to route
only IP packets and bridge all other data packets (R
OUTE IP/BRIDGE OTHER) or
route all IP data packets on this connection (R
OUTE IP).
5
Highlight AUTHENTICATION and press <ENTER> to change options related to how
the link is established. Default is T
X METHOD = NONE
and RX METHOD = NONE. If TX METHOD and RX METHOD are set to any option
other than N
ONE, TX/RX USERNAME and PASSWORD options appear. The
Total Access 850 supports various combinations of PAP, CHAP, and EAP for
PPP authentication.
6
Left arrow out of the AUTHENTICATION menus, highlight the PPP menu, and
press <E
NTER>. Use the PPP menus to configure parameters associated with
the PPP link. Refer to
L2 Protocol (T1 TDM–T1–PPP) > Config on page 118 for
more details.
7 Left arrow back to the main menu to save the changes.
Layer 2 Protocol Configuration – Ethernet Interface
Step Action
1
From the main menu, select L2 PROTOCOL and press <ENTER>.
2 Highlight the CONFIG menu for the ETH (Ethernet) interface and press <ENTER>.
3
Set mode to BRIDGE ALL. Using this menu you also have the option to route
only IP packets and bridge all other data packets (R
OUTE IP/BRIDGE OTHER) or
route all IP data packets on this connection (R
OUTE IP). Refer to L2 Protocol
(ALL–ETH–802.3) > Config on page 144 for more details.
4 Left arrow back to the main menu to save the changes.
Layer 2 Protocol (FRE) Configuration – T1 Interface (Continued)