Instruction manual

Total Access 850 System Manual Section 4 User Interface Guide

3. Verifying the Bridge Options

For more details on the configuration parameters discussed in this section, refer to the following pages:

Bridge menus beginning on page 145

4. Mapping the DS0s

For more details on the configuration parameters discussed in this section, refer to the following pages:

DS0 Map menus beginning on page 180

Bridge Options

Step Action

From the main menu, select BRIDGE and press <ENTER>.

2 Use the right arrow key to highlight CONFIG and press <ENTER>.

Select INTERFACES and press <ENTER>. Verify that the desired interface is

listed in this table.

4 Left arrow back to the BRIDGE > CONFIG menu.

Select BRIDGE TABLE and set the BRIDGE TABLE AGING to the desired time (in

minutes) it takes an entry to age out of the Bridge table.

6 Left arrow back to the main menu to save the changes.

DS0 Mapping Instructions

Step Action

From the main menu, select DS0 MAPS.

Verify that the ACTIVE MAP is set to either MAP 1 or MAP 2. This is the map that

is actively running on the unit. The unit has the ability to store two maps.

• To edit the current map, press <ENTER> on EDIT/VIEW MAP 1 to view the

map. (If Map 1 is the Active Map)

• To edit the standby map, press <ENTER> on EDIT/VIEW MAP 2 to view the

map. (If Map 2 is the Active Map)

The DS0 listed on the left side of the menu corresponds to DS0s (1 through 24)

on the network T1 interface. At least one DS0 must be mapped to the

ROUTER

to utilize the Total Access 850 for routing purposes.

Scroll down to the DS0 that will be mapped. (Any DS0 can be mapped to the

router.)

4 Set the SERVICE for the DS0 that you are mapping to TA IAD.