Instruction manual

Total Access 850 System Manual Section 4 User Interface Guide
64203376L1-1B © 2004 ADTRAN, Inc. 207
3. Setting the Router Options
For more details on the configuration parameters discussed in this section, refer to the following pages:
Router Ethernet Interface Configuration menus beginning on page 148
Router Network Interface Configuration menus beginning on page 148
Router Default Gateway menus beginning on page 157
Router Options – Ethernet Interface
Step Action
1
From the main menu, select ROUTER and press <ENTER>.
2 Use the right arrow key to highlight CONFIG and press <ENTER>.
3
Select INTERFACES and press <ENTER>. Use the right arrow key to highlight the
S
ETUP field for the ETH (Ethernet) interface and press <ENTER>.
4 Highlight the PRIMARY IP field and press <ENTER>.
5 Set the IP ADDRESS of the Ethernet port.
6 Set the SUBNET MASK for the Ethernet port.
7
By default, RIP is disabled on the Ethernet interface. If RIP needs to be
enabled, highlight the RIP field and press <E
NTER>. Set the appropriate
V
ERSION, RIP METHOD, DIRECTION, and V2 SECRET (where applicable) to
configure RIP on the interface. For more details, refer to
Router > Config >
Interfaces (ETH) > Sub-Interface on page 148.
8
Press the left arrow key to return to the Ethernet sub-interface menu (displays
P
RIMARY IP and SECONDARY IP).
9
If your application requires additional secondary IP address, highlight the
S
ECONDARY IP field and press <ENTER>. The Total Access 850 supports up to
5 additional LAN segments. Enter each additional secondary IP address and
corresponding subnet mask. To add a new IP address entry, highlight the N
UM
field and press the <I> key. To delete an existing entry, highlight the N
UM field
for the entry to delete and press the <D> key.
10 Left arrow back to the main menu to save the changes.
Router Options – T1 Interface (L2 Protocol = ATM)
Step Action
1 From the main menu, select R
OUTER and press <ENTER>.
2 Use the right arrow key to highlight C
ONFIG and press <ENTER>.