Instruction manual

Section 4 User Interface Guide Total Access 850 System Manual

3. Verifying the Bridge Options

For more details on the configuration parameters discussed in this section, refer to the following pages:

Bridge menus beginning on page 145

Set mode to ROUTE IP. Using this menu you also have the option to route only

IP packets and bridge all other data packets (R

OUTE IP/BRIDGE OTHER) or

bridge all data packets on this connection (B

RIDGE ALL). Refer to L2 Protocol

(T1 ATM–T1–ATM) > Config > PVC Config > Setup (V35) on page 133 for more

details.

10 Left arrow back to the main menu to save the changes.

Bridge Options

Step Action

From the main menu, select BRIDGE and press <ENTER>.

2 Use the right arrow key to highlight CONFIG and press <ENTER>.

Select INTERFACES and press <ENTER>. Verify that the desired interface is

listed in this table.

4 Left arrow back to the BRIDGE > CONFIG menu.

Select BRIDGE TABLE and set the BRIDGE TABLE AGING to the desired time (in

minutes) it takes an entry to age out of the Bridge table.

6 Left arrow back to the main menu to save the changes.

Layer 2 Protocol (ATM) Configuration – T1 Interface (Continued)