Instruction manual

Section 5 DLP-3 Total Access 850 System Manual

1. Connect the Total Access 850 unit to your VT100 system (details found in DLP-1, Connecting a VT100

Terminal or PC to the CRAFT Port).

2. Log in to the system.

3. From the R

OUTER/CONFIG menu, select the INTERFACES option and press <Enter>.

4. Select S

ETUP for the ETH interface, then PRIMARY IP.

5. Highlight the IP A

DDRESS field and press <Enter>. Enter the appropriate IP address (as given by your

system administrator).

6. Highlight the S

UBNET MASK field and press <Enter>. Enter the appropriate subnet mask (as given by

your system administrator).

7. Highlight the D

EFAULT GATEWAY field and press <Enter>. Enter the appropriate default gateway (as

given by your system administrator).

8. Press the left arrow key to highlight the P

RIMARY IP submenu. This action saves your changes and

requires confirmation.

9. Escape out to the R

OUTER menu and log off by pressing <CTRL+L>.

Perform the steps below in the order listed.