Instruction manual

DLP-11 Saving and Transferring a Current Configuration Using

XMODEM

Introduction

The Total Access 850 supports configuration transfers from the unit via the rear CRAFT or RCU faceplate

CRAFT interfaces using a VT100 terminal or terminal emulator (with XMODEM). This DLP provides the

steps for a successful configuration transfer using either the rear

CRAFT or RCU faceplate CRAFT port

and XMODEM.

Tools and Materials Required

• VT100 terminal or PC with VT100 terminal emulation software

• XMODEM software

To prevent electrical shock, do not install equipment in a wet location or during a

lightning storm.

Electronic modules can be damaged by static electrical discharge. Before handling

modules, put on an antistatic discharge wrist strap to prevent damage to electronic

components. Place modules in antistatic packing material when transporting or storing.

When working on modules, always place them on an approved antistatic mat that is

electrically grounded.