Instruction manual

Total Access 850 System Manual Section 4 User Interface Guide

SYSTEM CONFIG

Set up the unit’s operational configuration from the SYSTEM CONFIG menu. Figure 4 shows the items

included in this menu.

Figure 4. System Config Menu

SYSTEM CONFIG > MANAGEMENT

Set up the CRAFT PORT, TELNET ACCESS, SNMP MANAGEMENT, and FDL MANAGEMENT from this menu.

SYSTEM CONFIG > MANAGEMENT > CRAFT PORT

Set up the CRAFT PORT parameters from this menu. The unit’s VT100 CRAFT port can be accessed via an

RJ-48 connector located on the rear of the unit, or via the DB-9 connector on the front of the unit.

SYSTEM CONFIG > MANAGEMENT > CRAFT PORT > PASSWORD PROTECT

When PASSWORD PROTECT is set to NO, the CRAFT port is not password protected. When set to YES (def),

the unit will prompt for a password upon startup.

SYSTEM CONFIG > MANAGEMENT > CRAFT PORT > PASSWORD

Enter the user-defined password (up to 30 alphanumeric characters including spaces and special

characters) to protect the

CRAFT port. By default, no password is entered. Table 2 on page 76 provides

instructions for changing the password.

Connecting directly to the CRAFT port provides full access to all menus. Enable the

password on the

CRAFT port to protect against unauthorized access.