Instruction manual

Section 4 User Interface Guide Total Access 850 System Manual

SYSTEM CONFIG > MANAGEMENT > CRAFT PORT > IDLE TIME

This option defines the amount of time in minutes user may stay connected without any activity on the

CRAFT port before the user is automatically logged out of the system. A value of 0 disables this inactivity

timer function enabling users to stay connected until manually logged out. The value range is

0 (def) to 255

(minutes).

SYSTEM CONFIG > MANAGEMENT > CRAFT PORT > BAUD RATE

This is the asynchronous rate that the CRAFT port will run. The possible values are 300, 1200, 2400, 4800,

9600, 19200, 38400

, 57600, and 115200. The default value is 9600.

SYSTEM CONFIG > MANAGEMENT > CRAFT PORT > DATA BITS

This is the asynchronous bit rate that the CRAFT port will run. The possible values are 7 or 8 (def) bits.

SYSTEM CONFIG > MANAGEMENT > CRAFT PORT > PARITY

This is the asynchronous parity that the CRAFT port will run. The possible values are NONE (def), ODD, or

EVEN.

SYSTEM CONFIG > MANAGEMENT > CRAFT PORT > STOP BITS

This is the number of stop bits used for the CRAFT port. The possible values are 1 (def), 1.5 or 2.

SYSTEM CONFIG > MANAGEMENT > TELNET ACCESS

Activate the Telnet access and set up the various Telnet parameters from this menu. The Total Access 850

supports up to five simultaneous Telnet sessions.

SYSTEM CONFIG > MANAGEMENT > TELNET ACCESS > ACCESS

Sets ACCESS to ON or OFF. The factory default value for this parameter is ON.

Table 2. Instructions for Changing Passwords

Step Action

Select the PASSWORD field—a new PASSWORD field displays.

2 Type the new password in the ENTER field.

3 Type the new password again in the CONFIRM field.

The Total Access 850 ships with default Telnet Access parameters of: guest (user),

password (password). Change this password during the initial configuration to protect

your unit.