Instruction manual

Section 4 User Interface Guide Total Access 850 System Manual

SYSTEM CONFIG > MANAGEMENT > SNMP MANAGEMENT > TRAPS

Sets up the trap manager name and IP from this menu.

SYSTEM CONFIG > MANAGEMENT > FDL MANAGEMENT

Enables the FDL management and configures mode and IP addresses from this menu.

SYSTEM CONFIG > MANAGEMENT > FDL MANAGEMENT > MODE

This enables the FDL (only in ESF mode) to be used for management. Learning mode can also be enabled

so the unit can "learn" its IP configuration to be used for its FDL management. Once it learns this

information from, for example a Total Access 4303, the configuration items populate. The factory default

ON.

PRIVILEGE

The access for this manager can be assigned three levels. The factory default is NONE.

NONE

No access is allowed for this community or manager.

GET

Manager can only read items.

GET/SET

Manager can read and set items.

MANAGER IP

This may be used in conjunction with the Netmask field to define a range of manager IPs. A netmask

of 255.255.255.255 defines a single IP as the manager host IP. The default value is

0.0.0.0.

NETMASK

The mask is used to determine which bits of the MANAGER IP are significant. A "0" bit means "don't

care." A "1" bit means that the corresponding address bits in the incoming SNMP packet must match

the address bit in the defined

MANAGER IP. The netmask of 255.255.255.255 defines a single IP as the

manager host IP. The default value is

0.0.0.0.

Displays the index number in the SNMP traps table.

This list allows up to 20 managers to be listed to receive traps.

MANAGER NAME is the text string describing the name of the entry. It is intended for easy reference

and has no bearing on the SNMP trap function. You can enter up to 31 characters in this field. The

factory default is no entry in the manager name field.

MANAGER IP

This is the IP address of the manager that is to receive the traps. The factory default is 0.0.0.0.