Installation guide

BlueSecure™ Access Point 1800 Installation Guide
16
VII. Connecting and Powering the BSAP
Follow these instructions to connect your BlueSecure BSAP to your Bluesocket WLAN and then
power it up:
1. Make a note of the 12-character MAC address and the serial number listed on the back of
the BSAP-1800 before mounting the BSAP to a wall or other surface. You will need this
information during configuration.
2. Position the BSAP-1800 for best radio performance.
The BSAP-1800 should be place where it has the best unobstructed view of the coverage
area. If possible, mounting the BSAP-1800 on the ceiling will provide the best performance
in a typical office environment. For more information, please refer to Bluesocket’s web site.
3. The BSAP derives its operating power directly from the RJ-45 connector when connected to
a device that provides IEEE 802.3af compliant Power over Ethernet (PoE).
Caution: If the BSAP is used in a medical environment, it must use an IEC/EN60601-1
compliant power adapter. See