Installation guide

BlueSecure™ Access Point 1800 Installation Guide
17
for a description of the IEC/EN60601-1 compliant power adapter.
Verify that the PWR LED stops flashing and remains on, and that the other status LEDs start
functioning as described in the section entitled
LED Indicators
.
4. Connect the BSAP to your Bluesocket WLAN.
You can connect the BSAP-1800 to a 10/100/1000 Mbps Ethernet through a network device
such as a hub or a switch, or to a 1000BaseT Gigabit Ethernet interface. Connect the RJ-45
Ethernet connector on the BSAP’s back panel to your network using category 5 UTP
Ethernet cable. When the BSAP and the connected device are powered on, the BSAP’s
Ethernet Link LED should light indicating a valid network connection.