Installation guide

BlueSecure™ Access Point 1800 Installation Guide
22
Enter 2 at the main menu to apply your configuration changes, reboot the BSAP, and put
the new configuration settings into effect.
When the BSAP completes its reboot, it will connect to and download its configuration from
the home BSC you have configured via the CLI.
Using the BSAP’s Site Survey Mode
The BSAP provides a site survey mode that is useful when you are conducting a site survey to
determine optimal RF coverage for your facility.
In site survey mode, the BSAP continually beacons the SSID “site_survey_chn#_pwr#” from its
802.11a/n and 802.11 b/g/n radios at a rate of 100 milliseconds. Here are the options to
configure site survey mode:
1. Select Option “a” from the main menu to enter the site survey sub-menu.
Figure 5: BSAP CLI Site Survey Configuration Menu
2. Select the Interface (11b/g/n or 11a/n) to configure. All the radio settings that are
configured after this interface is setup will apply to the configured interface.
3. Set Antenna Type (Doesn’t apply to the 1800).
4. Set Channel - channel to transmit the beacons.
5. Set Transmit Power - transmit power of the beacons – levels 0-10.