Specifications

tagged e11,e12
This example assumes the BSC's Protected interface is plugged into switchport e10, Managed
interface into e11, and 3rd Party AP into e12.
***Notice the protected physical and managed physical interfaces are untagged and the
managed vlan interfaces are tagged. The physical interfaces of the BSC cannot send or
receive dot1q tags, only the vlan interfaces can.
Wired Support
If you are required to support wired users on the BSC you may be required to put the BSC's
managed interface on a trunk port also. For example you may have a conference room where you
could assign switchports to the guest vlan 15 so that visitors can get the BSC's login page and be
policed by the BSC's role based authorization. If the wired users were placed on the managed
physical network trunking/tagging would not be required.
Edge-to-Edge
The Edge-to-Edge feature essentially disables the EherIP tunnel from the BSAP to the BSC on a
per ssid basis. Therefore you may be required to put the BSAP and the managed physical
interface on trunk ports if you are using the Edge-to-Edge feature. If the Edge-to-Edge ssid is
assigned to the managed physical network (vlan 0) then trunking/tagging would not be required.
How can I allow all users to bypass the login page of the BSC and go straight out to the
internet without having to authenticate?
Set the default role under network>managed to an appropriate role. Upon obtaining an IP address
users will be placed into that role bypassing the login page and authentication.
How do I default the configuration of the BSC?
From the web based administration console:
-Go to maintenance>configuration backup/restore
-Select "Reset to default settings"
-Click reset
From the serial console menu:
-Connect to the serial console port using a 9 pin null modem serial cable and a terminal
emulation program (9600, 8, none, 1, none).
-The serial console password is wg1000s.
-Choose option 1 for dbinit