Specifications

Chapter 3. Using the Express Configuration Program
61203153L3-20 Express 3000 SP User Manual 3-5
FACTORY DEFAULT SETTINGS
The factory default configuration settings suffice for most applica-
tions. However, you can change these settings to create custom config-
urations using ISDN and User profiles (see
Understanding Profiles
on
page 3-6). You can also restore these settings at any time.
Restoring Factory Default Settings
To restore the Express 3000 SP to the factory default settings, follow
the steps below:
USING ON-LINE HELP
The ADTRAN Express Configuration program includes on-line help.
You can access this help in two ways:
1. Click on
Help
in the left panel of the ADTRAN Express Configu-
ration window.
OR
2. From any dialog box, click the
What’s This?
button ( ) in the
top, right-hand corner of the dialog box, and then click again
over the item in question.
Instructions for Restoring Factory Default Settings
Step Action
1
Set
DIP switch 2
to the
OFF (Up)
position.
2
Disconnect the Express 3000 SP from the power source.
3
Reconnect the power source for the Express 3000 SP.
4
When the
PWR LED
flashes, set
DIP switch 2
to the
ON (Down)
position. (See also
Setting the DIP Switches
on
page 2-7)