Instruction manual

IP 700 Series Phone Administrator Guide Setting the Minimum Required Parameters
6AOSAG0001-31A Copyright © 2011 ADTRAN, Inc. 21
Server (Reg.x.Servers) Defines which pair of proxy and registrar
servers should be used for this phone line.
Config File
Web Interface
Enable Line (Reg.x.Enable) Enables or disables registration for a phone
line.
Config File
Web Interface
DID (Reg.x.Did) Specifies the direct inward dialing (DID)
number. Certain proxies may require a DID
number that is different from the user name for
authentication. If DID is not set, the
Reg.x.AuthUserId is used both for
authentication and as the DID number.
Config File
Web Interface
Realm (Reg.x.Realm) Identifies the calling realm of the phone line.
This is used to decide which type of dial plan to
apply to this phone line.
Valid entries are: GE, PE, GP, or GI.
General External (GE) - Used for general
non-PBX-type outside lines. Lines of this type
use the DialPlanExternal dial plan.
Private External (PE) - Used for private (few
users) non-PBX-type outside lines. Lines of this
type use the DialPlanExternal dial plan.
General PBX (GP) - Used for PBX call
appearances that require an additional digit,
such as 9 to be dialed to access outside
numbers. Lines of this type use the
DialPlanPbx dial plan.
General Intercom (GI) - Used for intercom lines
configured for key system operation. Lines of
this type use the DialPlanIntercom dial plan.
Config File
Web Interface
Dial Plan If a dial plan is not specified, the default dial
delay (3 seconds after the last digit is dialed)
will be used before dialed digits are sent to the
proxy. You should specify DialPlanPbx,
DialPlanIntercom, and/or DialPlanExternal as
required by your line configuration settings
(Reg.x.Realm). GE and PE realms use
DialPlanExternal, GI uses DialPlanIntercom,
and GP uses DialPlanPbx.
Config File
Web Interface
SNTP Server IP Address
(SntpServer)
Optional. Identifies the server from which to
retrieve the time.
DHCP
Config File
Web Interface
Table 2. Minimum Parameters Required for Operation (Continued)
Parameter Description Source