Instruction manual

Appendix A. Configuration and Line Parameters ADTRAN IP 700 Series Phone Administrator Guide
76 Copyright © 2011 ADTRAN, Inc. 6AOSAG0001-31A
Speed.n.Realm Internal,
External,
PBX,
Other
Assigns a call appearance type to a Speed
dial button. Used to select the facility type
to originate calls on. Other value may be
used for post-call setup dialing strings.
Default: Internal
Config File
Phone Interface
Web Interface
SpreHfaai ASCII
String
Specifies the dialing prefix used to initiate
HFAAI calls.
Default: **
Config File
Web Interface
SprePageOverhead ASCII
String
Specifies the dial access code used to
access the overhead paging system. If this
value is null, then overhead page is not
presented on the soft key as an option.
Default: *30
Config File
Web Interface
StunServer ASCII
String
Specifies the FQDN or IP address of the
STUN server, which may be required for
operating phones behind NAT routers.
Config File
Web Interface
SubNetMask N/A Indicates the network mask for the phone.
Default: 0.0.0.0
DHCP
Phone Interface
Web Interface
SubsGrp.i.Type BLF Indicates the subscription type. The
subscription interval is as specified in the
FeatureExpires parameter.
Default: BLF
Config File
Web Interface
SubsGrp.i.Uri Request
URI
Indicates the Request URI to use in the
subscribe sent to the server for
subscribing to respective status group
updates. The subscription interval is as
specified in the FeatureExpires
parameter.
Config File
Web Interface
SubsGrp.i.Line 0 to 11 Assigns the value of x in reg.x.* to the
subscription group i. The value of i can be
1 to 6 on the IP 706 and 1 to 12 on the
IP 712 phone.
Default: 0
Config File
Web Interface
Table 12. Configuration Parameters (Continued)
Parameter Value Type Description Sources