User Guide

Installing the IPR-S1000

III Installing the IPR-S1000

1. Connecting the cables

The appropriate cables are necessary to connect the IPR-S1000 to the

Ethernet network as well as to the satellite antenna. Refer to the

following list and illustrations to correctly locate the different

connectors.

Connectors

- Ethernet 10/100 Mbps RJ45 connector

- Coaxial satellite connector, F type.

- DB-9 serial connector (console / modem).

Making the connection

Note: To help you making the connection, refer to the illustration on

the next page.

- Inserting the Multimedia Card (MMC)

Before inserting the MMC into the slot, make sure the card is correctly

oriented. The right notch of the MMC must be directed towards the slot.

Note: If the MMC is not properly inserted, the unit will not boot and

the LCD screen will say «IPR-S1000, Booting: Wait...».

- Connecting to the Ethernet network

Connect an Ethernet cable to the Ethernet connector.

Note: For better results, use a Shielded Twisted Pair (STP) category

5 cable.

- Connecting to the satellite antenna

Connect the satellite antenna using the F type connector on the back

of the equipment.

Note: Make sure the cable is inserted and secured by tightening the

connector.

- Connecting the power cord

Connect the power cord.

Do not extract the MMC when the power is ON. It can

cause damage to the equipment.