User Guide

Configuring the IPR-S1000
79
the interface that one listens to.
quick: Allows to have a reduced display (minimum of essential information).
timeout: Maximum duration of the capture (in second).
timestamp: Displays time information on each packet (time is specific to the
equipment).
verbose: Defines a level of smoothness of analysis. The more the level is
raised, the more the analysis is fine.
lastprofile
Prints the last loaded profile (followed by a «*» if modified).
list
Lists all available profiles.
load + name of the profile
Loads a profile.
loadfactory
Loads the factory profile.
ls
Lists all available profiles.
mget ATTR1 ATTR2 ...
Retrieves multiple attribute values. Pressing Tab after «get» will
display all the available attributes (see part C: sections and attributes).
They will be summed up in the next section.
mv + former_name new_name
Allows to rename a profile.
nat (Network address translation)
Displays NAT informations.
stat: Provides statistics relating to address translation.
netstat (Network statistics)
Getting network statistics.
arp (address resolution protocol): Protocol allowing to connect an IP address
and an Ethernet address.
iface: Statistics per interface.
proto: Statistics per protocol.
route: Routing table.
ping
Sends ICMP ECHO_REQUEST packets to network hosts.
count: The number of ECHO_REQUEST.