User Guide

Configuring the IPR-S1000

tftpput: Allows to put a kernel or a profile on the specified TFTP server.

version: Displays two version numbers. The first one is the system version, and

the second one is the version of the satellite reception’s software.

traceroute + IP address or «host» name

Prints the route that packets take to reach network host.

numeric: Prints hop addresses numerically rather than symbolically and

numerically.

timeout: The process of traceroute will not exceed nsecond.

tos: Sets the type of service in probe packets to the following value (default

zero). The value must be a decimal integer in the range 0 to 255.

verbose: Verbose output. Received ICMP packets other than

TIME_EXCEEDED and UNREACHABLEs are listed.

wait: Sets the time (in seconds) to wait for a response to a probe (default 5

sec.).

tsdump

TS Dump is an MPEG2-TS (Transport Stream) monitoring tool. It can

perform the following tasks:

-Display the selected TS packets in different ways (hexa, hexdump

style...),

-Record the selected TS packets into a file (using the browser or a FTP

server),

-Display statistics of the selected PIDs.

display_dump_date: If selected, ts dump will display the start and end dates at

the end of the dump.

display_pid_nbr: If selected, ts dump will display the PID number before each

TS packet.

diplay_pid_rate: If selected, ts dump will display each PIDs bit rate at the end

of the dump.

display_pkt_count: If selected, ts dump will display the number of TS packets

received for each PID at the end of the dump.

display_which_bytes: The number of displayed octets for each packet.

display_which_pkts: The interveal of packages between two postings.

ftp_addr: Access parameters to FTP server which will store TS flow.

ftp_login: Access parameters to FTP server which will store TS flow.

ftp_passwd: Access parameters to FTP server which will store TS flow.

ftp_path: Access parameters to FTP server which will store TS flow.

ftp_port: Access parameters to FTP server which will store TS flow.

mode_ftp: Selects the FTP analysis mode.

mode_hexa: Screen select mode (hexadecimal format).

mode_hexaline: Screen select mode (hexaline format).

mode_hexdump: Screen select mode (hexdump format).

mod_stat: Displays statistics only, not packages.