Troubleshooting guide

MX2820 System Manual
5-16 61186003L1-1D
CLOCK MODULE MENU TREE
Figure 5-5 shows the menu tree for the MX2820 Clock Module.
Figure 5-5. MX2820 Clock Module Menu Tree
1. Configuration
2. Provisioning
3. Status
3. Protection
Note: An asterisk (*) indicates default setting
2. Service States
4. Save Provisioning
CLEI Code
Serial Number
Part Number
Code Checksum
Code Version
Boot Version
Boot Checksum
Self Test
1. Timing Mode
3. Termination
2. Timing Type
6. Card Reset
1. Clock Interface
5. Restore Factory Defaults
7. Auto Save
8. Card Pair ID
2. Enabled*
1. Disabled
1. Perform Manual Switch
2. Perform Manual Switch From Primary Refrence
3. Automatic Clock Card Switch
4. Automatic Clock Reference Switch
5. Minimum Switching Period
6. Maximum Switching Threshold
1. Card CLK A Equipment Provisioned State
Card CLK A Equipment Functional State
2. Card CLK B Equipment Provisioned State
Card CLK B Equipment Functional State
1. External Timing*
2. Force Hold Over
1. Disabled
2. Enabled*
1. SF/ESF*
2. All Ones
Shelf: 1 Slot: CLK A ADTRAN MX2820 System 01/23/04 10:09
Unacknowledged Alarms: NONE TID: ADTRAN MX2820
Status
Clock Status, Active
Master = CLK A
Clock Refrence = Primary
PRI Clock Status= OK
SEC Clock Status= OK
CTL Status = Norm
Card Pair State
Alarm = None
Protection = Circuit
Card Comm. = OK
Slot CLK A
Status = Active
Slot CLK B
Status = Standby
Selection: '?' - System Help Screen
7. Clear Number of Switches
3. Primary Clock Failure Alarm
4. Secondary Clock Failure Alarm