Troubleshooting guide

Section 5, User Interface Guide - UIG-540, SCU Utilities
61186003L1-1D 5-113
COPYING OF ACCESS MODULE PROVISIONING
This feature allows provisioning information to be copied from one module to another.
To perform the cloning function, perform the following steps:
1. Select COPY MODULE PROVISIONING from the Smart Start screen.
Figure 5-81 provides an illustration of the SCU Copy Module Provisioning screen.
Figure 5-81. Copy Module Provisioning Screen
2. Select the desired source for provisioning data and press ENTER. Figure 5-81 on page 5-113
indicates that the M13 MUX in slot 1 is the source.
Table 5-38. Cloning the Provisioning Data
Entity Response
User Interaction The user selects a source module. The SCU compares the module type to that
in the rest of the system and displays a list of all eligible candidates to receive
a copy of the provisioning. The user selects one or more modules, and the SCU
will mediate the exchange.
Source The source module, upon request from the SCU, packages its provisioning
information and sends it to the SCU. The SCU retains this provisioning
information until another source is selected, or the SCU is reset. This allows
the re-provisioning of a replacement module if only a single module is being
used in the system.
Receiver The receiving module accepts the packet and reconfigures itself accordingly.
Shelf: 1 ADTRAN MX2820 System 04/22/04 14:25
Unacknowledged Alarms: TID: HTVLALEXD16
Copy Module Provisioning
1 A - MX2820 M13.. [None] B - ............ [None]
2 A - MX2820 M13.. [None] B - ............ [None]
3 A - ............ [None] B - ............ [None]
4 A - MX2820 STS1. [None] B - ............ [None]
5 A - ............ [None] B - ............ [None]
6 A - ............ [None] B - ............ [None]
7 A - ............ [None] B - ............ [None]
Select Source Mux (1..7): 1