Troubleshooting guide

Section 5, User Interface Guide - UIG-540, SCU Utilities
61186003L1-1D 5-115
Figure 5-83 provides an illustration of the Copy Module Provisioning screen with source and
candidate identified.
Figure 5-83. Copy Module Provisioning, Confirmation
4. Input a Y, and press ENTER to copy from the Source to the Candidate, or input an N, and
press
ENTER to cancel the copy.
5. If
Y is selected to continue, the provisioning data is copied and the Candidate identifier
changes to Complete.
6. If
N is selected, then a blank Copy Module Provisioning screen will display again asking for
source selection.
BACK-UP LINECARD PROVISIONING
The BACK-UP SCU PROVISIONING TO LINECARDS and BACK-UP LINECARD PROVISIONING TO SCU options in the
Smart Start menu are in place to expedite the Smart Start process. The module provisioning
and SCU provisioning are transferred only once per minute. If a module is removed prior to
that one minute save, the Smart Start provisioning image will not match the latest configu-
ration.
When the task is complete, return to the desired screen by pressing
ESC until that screen
appears.
Shelf: 1 ADTRAN MX2820 System 04/22/04 14:30
Unacknowledged Alarms: TID: HTVLALEXD16
Copy Module Provisioning
1 A - MX2820 M13.. [Source] B - ............ [None]
2 A - MX2820 M13.. [Candidate] B - ............ [None]
3 A - ............ [None] B - ............ [None]
4 A - MX2820 STS1. [None] B - ............ [None]
5 A - ............ [None] B - ............ [None]
6 A - ............ [None] B - ............ [None]
7 A - ............ [None] B - ............ [None]
Copy Source: MX2820 M13 in slot 1A to Destination: MX2820 M13 in slot 2A.
Execute (Y/N = Yes/No):