Troubleshooting guide

61186003L1-1D 6-13
NTP-005
SCU Provisioning (System Management)
INTRODUCTION
This NTP provides the tasks for provisioning the System Management parameters for the
MX2820 System Controller Unit (SCU). System management tasks include:
• Date and Time
• Network Management
– Internet Protocol (IP) network settings (Ethernet Interface)
– Network Service Ports
– Trivial File Transfer Protocol (TFTP) Server
• Simple Network Management Protocol (SNMP) management options
PREREQUISITE PROCEDURES
Before beginning the tasks listed in this NTP, the user should determine if the MX2820 system
requires connecting to a Network Management (NTWK MGMT) interface. Based on this infor-
mation, the user should know which steps of this NTP are required for the intended use of the
MX2820 shelf.
The following procedure must be completed before provisioning the SCU. If necessary, refer to
the appropriate documentation before proceeding.
• “NTP-001, Shelf and SCU Installation”
TOOLS REQUIRED
• VT100 terminal or PC with VT100 Terminal Emulation software
MATERIALS REQUIRED
• DB-9 data cable for the RS-232, serial VT100 interface (Craft interface)