Technical data

90362-01 NetBlazer LS Configuration Worksheets B-7
Worksheet 4. LAN Setup for AppleTalk
To configure your NetBlazer to route AppleTalk on the LAN:
1. Set your NetBlazer name and password (Worksheet 1).
2. Select “NetBlazer port setup” from the Main Menu screen.
3. Select “AppleTalk LAN” from the NetBlazer Port Setup screen and work through the
fields below that apply to your network.
en0 router type: ❏ none ❏ seed ❏ nonseed ❏ nonroute
lt0 router type:
❏
none
❏
seed
❏
nonseed
❏
nonroute
Select one router type per interface. See “Configuring AppleTalk Routing” on page 4-8 for
information on the differences between seed, nonseed, and nonroute.
4. If you select “Seed” for en0, configure the NetBlazer as a Seed Router using the fields
below.
Begin range:
End range:
New zone:
If you have more than one new zone for a range, be sure to press Enter after each new zone name.
5. If you select “Seed” for lt0, configure the NetBlazer as a Seed Router using the fields
below.
Begin range:
New zone:
You can only have one range and one zone per range.
If you’ll also be routing IP and/or IPX, use Worksheet 2 and Worksheet 3 as you continue with the
configuration. Or, you may want to save your configuration at this point; return to the Main Menu
and select “Save/Exit” to save.