Technical data

90362-01 NetBlazer LS Installation 2-3

NetBlazer Front Views

Figure 2-3 shows the front panels for both the ISDN and Dual DTE models

of the NetBlazer LS. Both models feature a rocker-type power switch on the

left side of the front panel.

Figure 2-3. NetBlazer LS Front LED Panels

Both NetBlazer models show PWR (Power) and RDY (Ready) status indica-

tors by the power switch. The

PWR LED is on when AC power is applied to

the NetBlazer. The

RDY LED is on when the NetBlazer has completed boot-

ing up.

Note:

The pinhole to the right of the power switch is used to reset your NetBlazer

to the factory defaults by erasing all saved configuration files. To reset the

NetBlazer, turn the NetBlazer’s power off and insert one end of a straight-

ened paper clip into the pinhole. Holding the paper clip firmly pushed in,

turn the NetBlazer back on and continue to press in on the paper clip for five

or more seconds. When you release the paper clip, the NetBlazer will boot

up using factory default settings.

ISDN

Dual DTE

NetBlazer

LS ISDN

POWER PWR RDY ETHERNET LOCALTALK DTE BRI

TRANS

RECV

COL

UTP/BNC

TRAN

RECV

NetBlazer

LS 2-PT

POWER PWR RDY ETHERNET LOCALTALK DTE A DTE B

TRANS

RECV

COL

UTP/BNC

TRAN

RECV