Technical data

90362-01 NetBlazer LS Installation 2-9
NT1 Connection to NetBlazer LS (ISDN only)
Power Requirements
Your NetBlazer LS is supplied with an autoranging, universal power supply
that automatically adapts itself to your line voltage. Your wall plug should
be a 110v (or 220v) connection. If for any reason you need to know the
power requirements, the NetBlazer LS ISDN (LS I-1BS) requires +5 Volts
DC; the NetBlazer LS 2-PT (LS 2S/A) or Dual DTE requires +5 Volts DC,
+12 Volts DC and -12 Volts DC.
ISDN Requirements
The NetBlazer LS ISDN model provides an integrated point to point Basic
Rate S/T interface.
To install the ISDN NetBlazer you need:
• ISDN phone lines installed at your location.
Warning:
The NetBlazer LS is designed to allow connection to LAN and WAN inter-
faces with the power turned on. However, as a general safety precaution,
turn off the power before making any connections. If the unit is being ser-
viced with the power applied, do not hold or wear any conductive or metallic
objects (for example, screwdrivers, watches, or rings) while making the
LAN and/or WAN connections.
NetBlazer LS
RJ48
S
RJ45
P
NT1
RJ48
S
RJ45
P
WT-MM1430-006 RJ45 - RJ45 Cable