Technical data

3-6 Using the Setup Utility 90362-01

When the telnet connection is established, you should see the

NetBlazer’s login prompt. Log in as

setup

to run the NetBlazer

Setup Utility. Refer to “Starting the Setup Utility” on page 3-7 for

instructions on using the Setup Utility.

AppleTalk Data Stream Protocol (ADSP) Connection

To configure the NetBlazer from a Macintosh using ADSP, perform the

following steps:

Start a communication program that supports ADSP on Macintosh

that is on the same LAN segment as the NetBlazer.

Select an ADSP connection from the communications program’s

Connections Settings dialog screen.

Choose the NetBlazer for a ADSP connection.

Note:

The NetBlazer’s default address is a temporary address defined by the IANA

(Internet Assigned Number Authority). This address cannot be used for

normal operation. You must assign the NetBlazer its own unique address.

After you have configured the NetBlazer for IP, you should remove the IANA

address from your host’s routing table and use the NetBlazer’s address for

subsequent connections with the NetBlazer.

Rest of the

Local Network

NetBlazer LS

Macintosh

LAN Segment

Requires communication

program that supports ADSP

such as MacTerminal or

PacerTerm.